What is Bollard Pull Test and Requirements for the Bollard Pull Test
WHAT IS BOLLARD PULL
 |
| Sumber: google.com |
What is Bollard Pull Test and Requirements for the Bollard Pull Test - Bollard pull is the static force exerted by a ship on a fixed tow line at zero speed. Trawl pull is a force exerted by a ship on a tow line at speed in another words Bollard pull is the maximum pulling capacity of a tug that can exert
WHY IN BOLLARD PULL NOT BHP
the BHP of the tug is not sufficient to show the efficiency because of loss in transmission, propulsion efficiency and propulsion type Whereas Bollard pull shows the efficiency of the maximum pulling capacity of a tug that can exert
TEST BOLLARD PULL
Bollard pull test is carried out by dynamometer comprised of load cell,load indicator. Loadcell is the force measuring link and it is made as part of the rope, connected to the towing hook
 |
| Sumber: google.com |
- Sustained Bollard Pull is the mean value of the pull during a specific time period (5 to 10 min.). If the measurements are taken every 30 sec., the sustained Bp is the mean value of the readings.
- Maximum Static Bollard Pull is the highest 30 second value read during the test. If the measurements are taken every 30 sec., the maximum static Bp is the highest mean value of two consecutive readings. Maximum Bollard Pull is the highest single value measured.
REQUIREMENTS FOR THE BOLLARDPULL TEST
- Test is carried out at slackwater
Trial site: should allow the use of a long enough towing line and be free of wind, waves, and be located in very deep water with no tides or currents. - The towline length should be enough to allow free water astern of the vessel. (200 meters minimum recommended).
- The tug has to be loaded to its designed waterline, in order to ensure the adequate immersion of the propellers.
- Wind speed during the test should not exceed 5m/s.
- The trial should be done with no currents if possible; if there’s a current, it should not exceed 1 knot.
- Measurement should be taken using a calibrated dynamometer or a mechanical load gauge.
- Steering during the trials should be avoided as much as possible.
- The readings on the dynamometer should be continuously recorded by a computer, or at 30 sec intervals if a mechanical load gauge is used.
- The maximum acceptable deviation of the dynamometer is +-2%.
- Communication between shore and tug should be excellent, for an accurate recording of data relating the bollard pull to the rpm.
- Bollard and the towing hook should be at the same height
Thank you for reading What is Bollard Pull Test and Requirements for the Bollard Pull Test on blog Marine Engineering
0 Response to "What is Bollard Pull Test and Requirements for the Bollard Pull Test"
Post a Comment